商品混凝土攪拌站面臨著激烈的市場競爭，為了在市場競爭中提高攪拌站競爭力，須加強混凝土攪拌站生產與運輸過程中的成本控制?，F在我們一起來看看攪拌一體車能從哪些方面把攪拌車油耗降到很低。八大招教你將攪拌車油耗降到較低！如下：

The commercial concrete mixing plant is facing fierce market competition. In order to improve the competitiveness of the mixing plant in the market competition, it is necessary to strengthen the cost control in the production and transportation process of the concrete mixing plant. Now let's take a look at how the mixer can reduce the fuel consumption of the mixer to a very low level. Eight tips to reduce the fuel consumption of mixer truck! As follows:

1、在行駛中發現攪拌車現在的滑行距離明顯減少，這時司機們應該檢查一下攪拌車的輪胎氣壓是否合乎氣壓標準。若輪胎充氣不足，耗油量也會增加。

1. When driving, it is found that the taxi distance of the mixer is obviously reduced. At this time, drivers should check whether the tire pressure of the mixer meets the pressure standard. If the tire is under inflated, the fuel consumption will also increase.

提示：適時為輪胎充足氣。

Prompt: Fill the tire with sufficient air at the right time.

2、檢查攪拌車輪胎的磨損程度，如果輪胎磨損嚴重時，就會經常出現打滑現象，增加耗油量。

2. Check the wear of the tires of the mixer truck. If the tires are seriously worn, they will often slip and increase fuel consumption.

提示：必要時可更換的輪胎。

Tips: tyres that can be replaced if necessary.

3、在攪拌車行駛中或啟動時發現車輪有異常響聲，網友們應該及時檢查軸承及剎車系統是否有故障。如果車輪轉動不正常，就會影響攪拌車的車速，使油耗加大。

3. If the wheels make abnormal noise when the mixer is running or starting, netizens should timely check whether the bearing and brake system are faulty. If the wheels do not rotate normally, it will affect the speed of the mixer and increase the fuel consumption.

提示：檢修軸承及剎車系統。

Prompt: overhaul the bearing and brake system.

4、攪拌車離合器打滑會使發動機的轉數丟失。當您在急加速時發現攪拌車發動機轉速表增加很快，但車速增加卻很慢，這時可以判定是離合器打滑了。

4. The slipping of the mixer truck clutch will cause the loss of engine revolutions. When you accelerate rapidly, you find that the engine tachometer of the mixer truck increases rapidly, but the speed increases slowly. At this time, it can be determined that the clutch is slipping.

提示：需要更換離合器片，離合器壓盤和驅輪。

Prompt: It is necessary to replace the clutch plate, clutch pressure plate and drive wheel.

5、當攪拌車已經行駛二三十萬公里時，通常會出現汽缸壓力不足的現象，這時油耗會明顯增加。

5. When the mixer has driven 230000 kilometers, the cylinder pressure is usually insufficient, and the fuel consumption will increase significantly.

提示：如果真的出現這種故障，那么攪拌車發動機就需要大修了。

Prompt: If such a fault occurs, the mixer engine needs to be overhauled.

6、當排氣管出現冒黑煙、油耗增D的現象時，需要檢查化油器。

6. When the exhaust pipe emits black smoke and the fuel consumption increases by D, the carburetor needs to be checked.

提示：如果化油器太臟可以用清洗劑直接向化油器進氣口噴一噴，若此時還冒黑煙，那只能把化油器拆開清洗了。

Tip: If the carburetor is too dirty, you can spray detergent directly on the carburetor air inlet. If there is black smoke at this time, you can only disassemble the carburetor for cleaning.

7、如果攪拌車火花塞使用的時間太長，也會出現油耗加大的現象。因為攪拌車火花塞損壞會使點火的N量下降，車提速減慢，導致油消耗明顯增加。

7. If the spark plug of the mixer truck is used too long, the fuel consumption will also increase. Because the damaged spark plug of the mixer will reduce the amount of ignition N, slow down the car's acceleration, and lead to a significant increase in oil consumption.

提示：應該換攪拌車火花塞了。

Tip: The spark plug of the mixer truck should be replaced.

8、當攪拌車的溫控開關和節溫器損壞時，會出現油耗增加的現象。因為攪拌車的溫控開關和節溫器損壞會使水溫降低，化油器不能正常工作，導致攪拌車油霧化不好，油耗量明顯增加。

8. When the temperature control switch and thermostat of the mixer are damaged, the fuel consumption will increase. Because the temperature control switch and thermostat of the mixer are damaged, the water temperature will be lowered, and the carburetor will not work normally, resulting in poor oil atomization of the mixer and a significant increase in oil consumption.

提示：定期檢查溫控開關和節溫器。

Tip: Check the temperature control switch and thermostat regularly.

八大招教你將攪拌車油耗降到較低就是以上的內容了，您對此有什么想咨詢了解的，就來我們網站http://www.gifcare.com進行咨詢吧！

Eight tips to reduce the fuel consumption of the mixer are the above. If you have any questions about this, please come to our website http://www.gifcare.com Consult!